
I had high hopes that replacing those parts would renew the car to a fair degree and keep me running strong for a while. However, another high-dollar problem has surfaced. Before I share details about that, I want to share about an upgrade that I did in 2026.
Remember, my car has a comprehensive communications suite, a desk with computer, and a refrigerator/freezer. The larger battery can power the setup for days. It’s been great! Click here to read more about that setup.
The crimps were firm, but the rings and 00-gauge cable were heating to 160°F in some places. My choice of terminal ring uses slightly thinner metal than better options. That meant that my crimping dies were not clamping down quite tightly enough to achieve a cold weld. I recrimped the rings with smaller dies an eliminated the voltage drop. The alternator now charges at 50 amps most of the time. I’m amazed that the alternator has held up so well for over 280,000 miles (450,000 km)!
The problem wasn’t persistent, perhaps because I was driving 99% on Interstate highways. Remember, the clutch is new — I suspected that it may be the culprit. Once home, I took the car back to my mechanic.
He checked for air in the line and proper clutch pedal movement. All was good. Then he removed the transmission to inspect the clutch. Everything was perfect, but he still cleaned everything inside just in case. All signs pointed to an issue with the transmission’s input shaft.
All symptoms that I can recall:
- Everything works normally when the engine is cold. Symptoms don’t present until after 10-15 minutes of driving.
- Shifter feels like the clutch is not fully depressed. Occasionally, it makes a light “kerchunk” as I slide the shifter into first gear or reverse.
- Sometimes, the engine shakes the entire car when I’m in first gear with the clutch pedal to the floor. Easing out the clutch pedal until the driveline grabs and then depressing it again resolves the shaking.
- Sometimes, the shifter will not go into any gear — sometimes, I cannot shift out of gear.
- All shifting is flawless with the engine off. I turn off the car if I need to work around a stuck shifter.
- Shifting between gears while the car is moving is flawless.
Thankfully, he covered all of that work under a shop warranty on the clutch. Any further efforts would be at my expense. My piggy bank is tapped after the other expensive maintenance actions and the recent trip to Oregon and back. What is next for me and this car?
The following items are still original and could cost a lot to replace if they’re next to fail:
- High pressure fuel pump – Remember, I still have the intermittent warm start issue. I work around it, but it could become more problematic. At least I can replace it myself.
- Alternator – I just said that the alternator is working great, but what about when it suddenly doesn’t? I can replace it myself.
- Lighting Package – I’m shocked that my bulbs are all still burning strong. Still, I keep in mind that replacing the bi-xenon lighting would be very expensive.
- Suspension, mounts, axles/boots, and bushings are still original. Once it’s time to replace one unit, it’s probably best to replace them all.
- Hoses and rubber bits – In my experience, these parts start to fail around the 11-year mark. I think I can replace them myself.
- Trunk struts – These are not expensive, but they’re getting tired nonetheless.
- Ventilation controllers – I have intermittent issues with one or more of the blend doors in my ventilation. I can usually get the offending flap to work, but there may come a day when it doesn’t. This is most apparent when the heat temporarily doesn’t blow on cold days.
- Sell the car as a repairable car. It’s a shame at this point since it has some new parts. A do-it-yourselfer could probably replace the transmission with a used part for about $2500. Not sure if that’s worthwhile for a 280,000-mile car, though. Then again, a DIY’r may like the idea of building onto a “beater” that’s already pretty fast. It’s an ideal platform for someone who’ll immediately replace the suspension and other tuner bits.
- Sell the car as a driveable parts car (end result for me is the same). The timing chain would be a sunk cost since the engine might get tossed, but I think that anyone who’s patient, has the space, and is proficient with the part-out game could turn the car into a profit.
- Part-out the car myself. I think the turbo, tires, and clutch may be worth the most. I cannot access the clutch, though. The car would become a heap in my driveway once I remove anything that makes the car undriveable or remove a body part. I don’t want that!
Park the car and repair it myself at some point. I don’t see that happening because I’d need to buy a transmission jack, an engine support (shown in this photo), and a lift with enough clearance to roll the transmission out from under the car. Then there’s the cost of the replacement transmission. Regardless, I don’t like the idea of parking the car for a long period while I procrastinate the repair.
It seems that options #1 and #2 are best for me. So, that leaves me with the task of replacing the car. Or I’d need another car to drive while my GTI sits in semi-retirement. But with what?
I already know that I want more space, an automatic transmission for easier backing of a trailer up my inclined driveway, and something that’s not performance-oriented so that I don’t get sucked into another money pit. 😀 I’ll share some thoughts in my next entry. I’ve shared more symptoms and thoughts in this video.
Feeling Defeated,
Scott
