I’ve never been one who’s able to leave “good enough” alone, especially when it comes to electronics. I like deep bass in my music. I outgrew my desire for twin 12-inch subwoofers decades ago, but I still like a deeper sound than what most factory stereo upgrades can give. I’ve been satisfied by various single 10-inch subwoofer systems for over 20 years. So it was a natural pursuit when I decided I wanted to upgrade my GTI. Of course, I “had” to add a ham radio and make the entire installation more complicated than necessary.
I had been mostly pleased with Volkswagen’s MIB II base stereo. It’s no powerhouse, but it’s more than adequate. I had originally planned to simply tap into the rear speaker wires to feed a signal converter, an amplifier, and then a subwoofer. I think I would have been satisfied with such a simple setup. Then VW decided to discontinue its first-gen Helix subwoofer accessory, meaning they slashed the pricing by more than 50% to clear their inventory. I had already purchased supplies for adding a subwoofer, so I already knew I wasn’t going to keep the Helix box after the initial installation and testing. But the super-clean wiring harness and 5-channel amp with DSP were too good to pass up, especially at that price! Helix is a great starting point for a system upgrade.
After installing the Helix system, I routed two pairs of the Helix amp’s subwoofer output into an Audio Control LC2i signal converter. The LC2i accepts up to 400 watts of speaker-level input, restores any bass that might be suppressed by the factory stereo, and then outputs line-level signals to my Rockford Fosgate Power T500X1BR 500-watt monoblock amplifier. I think Helix’s output is optimized for the six-inch subwoofers. So, adjusting the amplifier’s low-pass crossover frequency to block peaky mid-bass helps a lot.
I use a Rockford Fosgate Power T1S1-10 10-inch high performance shallow-mount subwoofer. My goal was to keep my spare tire and still have room for my other electronics. This subwoofer works in an enclosure as small as 0.4 cubic feet and with a mounting depth of just three inches. I use a PLC2 Remote Punch Level Control to fine-tune the subwoofer levels from the driver’s seat. It’s mounted just inches from the parking brake handle and is usually set to just 35%, leaving plenty of room to provide much more bass, if desired. In fact, 500 watts through this subwoofer is enough to produce ridiculous amounts of bass in a tiny car. I’ve shared a photo of the remote control in the album at the bottom of this page.
In short, I replaced the Helix subwoofer with a system that features double the driver size, triple the power, deeper bass response, and retention of the spare tire. Bonus: a 10-inch subwoofer in a hatchback provides even better bass than what I had previously enjoyed in sedans since there’s no “trunk” acting as a sound barrier. Those with the Fender system can duplicate my efforts using the parts and method I shared here. I have shared more photos of my project below. See a YouTube video about this system here.
I have addressed the physical attributes of the electronics panel, the amateur radio system, and a sophisticated 12V power distribution network on separate pages. All are complex enough to warrant their own pages. Feel free to ask any questions about my rather unusual setup.